There are many components which contribute towards producing quality flexographic printed products:- machine type, repro, plates, inks and the all important Anilox roller.

If the Anilox has dried ink in its cells, this will prevent the lay down of the ink volumes required.

Cleaning and preventative maintenance of the Anilox is essential. Hydro-Dynamic Products, in conjunction with a leading Anilox roller manufacturer, has developed effective user-friendly cleaning products which remove all dried ink from Anilox cells ensuring maximum ink volumes without damage to the roller.

A General Purpose Cleaner for solvent and UV based flexo inks. Pumped around inking / doctor chamber system, Flexolv ensures quick colour changes and removal of ink from Anilox cells. Use in conjunction with Loxolv gel for removal of dried ink from the Anilox roller. Flash Point >77°C. Low odour, user-friendly and will not damage Anilox roller cell wall. Classified non-hazardous under Supply, Handling and Transport Regulations. Available in 5 litre, 25 litre, 205 litre, 1,000 litre containers.


Anilox roller cleaning gel for solvent and UV based flexo inks. Removes dried ink from Anilox cells. Can be applied to Anilox roller in doctor chamber and flushed away by pumping Flexolv around inking system or off press, apply to Anilox and wash off by hand using Flexolv. Flash Point >77°C, low odour, user-friendly and will not damage Anilox roller. Classified non-hazardous under Supply, Handling and Transport Regulations. Available in 5 litre containers.


A ready-for-use general purpose cleaner for water based flexo inks. Pumped around inking/doctor chamber system, Hydroflex ensures quick colour changes and removal of ink from Anilox cells. Use in conjunction with Hydrolox gel for removal of dried ink from Anilox roller. Non corrosive, non flammable and will not damage Anilox roller. Classified non hazardous under Supply, Handling and Transport Regulations. Available in 25 litre, 205 litre, 1,000 litre containers.

Anilox roller cleaning gel for water based inks. Removes dried ink from Anilox cells. Can be applied to Anilox roller in doctor chamber and flushed away by pumping Hydroflex around inking system or off press, apply to Anilox and wash off by hand using Hydroflex. Non corrosive, non flammable, will not damage Anilox roller. Classified non hazardous under Transport Regulations. Available in 5 litre containers.

A concentrated general purpose cleaner for water based flexo inks. Recommended dilution: 1 part Hydroflex concentrate to10 parts water, but may be diluted with up to 50 parts water. Non corrosive, non flammable and will not damage Anilox roller when used at recommended dilution rate.

Classified non hazardous under Transport Regulations. Available in 5 litre, 25 litre, 205 litre, 1,000 litre containers.


To aid the removal of hard dried ink from Anilox rollers. Brass: For use on chrome rollers only. Stainless Steel: For use on ceramic rollers only.


The Anilox Hydroturbo Roller Washer is the quickest deep cleaner for use with steel and ceramic rollers. Simply apply the relevant cleaning gel and leave for a few minutes to penetrate the anilox cell. Then place the roller in the Hydroturbo tank and as the roller revolves the high pressure jet completely evacuates each anilox cell ensuring maximum ink density for the next job.